ZyWALL 2 Series User’s Guide
17-26 Remote Management Screens
Table 17-6 SNMP
LABEL DESCRIPTION
SNMP Configuration
Get Community
Enter the Get Community, which is the password for the incoming Get and GetNext
requests from the management station. The default is public and allows all requests.
Set Community
Enter the Set community, which is the password for incoming Set requests from the
management station. The default is public and allows all requests.
Trusted Host If you enter a trusted host, your ZyWALL will only respond to SNMP messages from
this address. 0.0.0.0 (default) means your ZyWALL will respond to all SNMP
messages it receives, regardless of source.
Trap
Community Type the trap community, which is the password sent with each trap to the SNMP
manager. The default is public and allows all requests.
Destination Type the IP address of the station to send your SNMP traps to.
SNMP
Service Port You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Service Access Select the interface(s) through which a computer may access the ZyWALL using this
service.
Secure Client IP
Address
A secure client is a “trusted” computer that is allowed to communicate with the
ZyWALL using this service.
Select All to allow any computer to access the ZyWALL using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the ZyWALL using this service.
Apply
Click Apply to save your customized settings and exit this screen.
Reset
Click Reset to begin configuring this screen afresh.
17.15 Configuring DNS
Use DNS (Domain Name System) to map a domain name to its corresponding IP address and vice versa.
Refer to the Internet Access chapter for more information.
