ZyWALL 2 Series User’s Guide
Firewall Commands L-5
Chart L-1 Firewall Commands
FUNCTION COMMAND DESCRIPTION
Config edit firewall set <set #>
rule <rule #> protocol <integer
protocol value >
This command sets the protocol specification
number made in this rule for ICMP.
Config edit firewall set <set #>
rule <rule #> log <none | match |
not-match | both>
This command sets the ZyWALL to log traffic that
matches the rule, doesn't match, both or neither.
Config edit firewall set <set #>
rule <rule #> alert <yes | no>
This command sets whether or not the ZyWALL
sends an alert e-mail when a DOS attack or a
violation of a particular rule occurs.
config edit firewall set <set #>
rule <rule #> srcaddr-single <ip
address>
This command sets the rule to have the ZyWALL
check for traffic with this individual source address.
config edit firewall set <set #>
rule <rule #> srcaddr-subnet <ip
address> <subnet mask>
This command sets a rule to have the ZyWALL
check for traffic from a particular subnet (defined by
IP address and subnet mask).
config edit firewall set <set #>
rule <rule #> srcaddr-range <start
ip address> <end ip address>
This command sets a rule to have the ZyWALL
check for traffic from this range of addresses.
config edit firewall set <set #>
rule <rule #> destaddr-single <ip
address>
This command sets the rule to have the ZyWALL
check for traffic with this individual destination
address.
config edit firewall set <set #>
rule <rule #> destaddr-subnet <ip
address> <subnet mask>
This command sets a rule to have the ZyWALL
check for traffic with a particular subnet destination
(defined by IP address and subnet mask).
config edit firewall set <set #>
rule <rule #> destaddr-range <start
ip address> <end ip address>
This command sets a rule to have the ZyWALL
check for traffic going to this range of addresses.
