Filter
Top Products
DUA1602-0AAA01
Before You Start 2-3
Before You Start
You must have a SuperStack II UPS installed and operating to use
the Management Module, in addition to one of the following
cables:
■
Twisted-pair cable for an Ethernet network
■
The patch cable (STP or UTP) for your Token Ring network type
Installing the Management Module
To install the Management Module, you need access to the
management power connector on the UPS and the cables that are
connected to your network.
1
Remove the blanking plate on the SuperStack II UPS rear panel.
Retain the screws.
.
Figure 2-3
Removing the Blanking Plate on the SuperStack II UPS
2
Slide the Management Module into the open slot and secure with
the blanking plate screws.
Make sure the RJ-45 connector is located at the bottom of the
Management Module.