3
C
ONFIGURING
T
HE
M
ANAGEMENT
M
ODULE
You must configure the SuperStack II UPS Management Module
before you can use it. The Management Module has a
configuration program that you can access by connecting the
module to a terminal or a computer with a terminal emulation
program.
Before You Start
Make sure you contact your network administrator for the
following values: IP address, Netmask (subnet mask), and Default
Gateway. For the Token-Ring model, you also need the operating
speed of the Token-Ring network (4 Mbps or 16 Mbps). Write
these values down for future reference.
To use the configuration screens for the Management Module,
you need:
■ A serial cable (see Appendix A)
■ A terminal with an RS-232 serial port, or a PC with a terminal
emulation program such as Windows Terminal®
The serial line should be set to 9600 baud, No parity, 8 bits, and 1
stop bit. The configuration program always runs at these settings.
Local Configuration
To connect the module to the terminal and start the configuration
program:
1
Plug the male end of the serial cable into the serial port labeled
“TERM.”