Filter
Top Products
DUA1602-0AAA01
3-2
C
HAPTER
3: C
ONFIGURING
T
HE
M
ANAGEMENT
M
ODULE
2
Plug the other end of the serial cable into the serial port on the
back of the terminal.
3
Press [Return]. The Main Configuration screen for the module type
appears (“Figure 3-1 Main Configuration Screen for Ethernet”
or
“Figure 3-2 Main Configuration Screen for Token Ring”
).
If the Main Configuration screen does not appear, press [Return]
and make sure the Management Module is properly connected to
the UPS (see “Installing the Management Module”).
If you still do not see the Main Configuration screen, check the
following conditions:
■
Check the communications settings of the terminal you are
using. It should be set to 9600 baud, No parity, 8 bits, and 1
stop bit.
■
If the serial configuration is correct, check the cable between
the module and terminal to be sure all connections are secure.
■
Make sure your terminal program is on the correct
communications port for your RS-232 connection.
■
Verify that the management power cable is connected to the
UPS.
Using the Configuration Screens
Each version of the Management Module has its own configuration
screen. When you start the configuration program, the Main
Configuration screen for your module appears. Figure 3-1 shows
the screen for the Ethernet module. Figure 3-2 shows the screen
for the Token-Ring module.
The Main Configuration screen shows the current configuration
settings for your Management Module. A list of command (CMD)
options are available in the left column of the screen.