Filter
Top Products
108 CHAPTER 5: INSTALLING NETWARE CLIENT AND SERVER DRIVERS
Server Feature Commands
DynamicAccess server feature commands for NetWare can
be used to create sophisticated configurations of groups
and for troubleshooting. You can enter them at the
NetWare command line or add them to the appropriate
NCF file. The commands are summarized below.
As shown in the examples, all commands are preceded by
the keyword lbrsl.
group
This command creates groups from specified slot
parameters for primary and secondary NICs.
display status
This command displays information about all groups, or if a
primary slot parameter is specified, only about the specified
group. A separate message is displayed for each loaded
frame type. Board numbers are also displayed. Information
about the relationship between the board numbers and the
frame types is shown in the NetWare 5 Console Monitor.
On the Available Options screen, select LAN/WAN drivers
for this information.
Syntax
lbrsl group lb addr RxIPAddr pri_slot
sec_slot [sec_slot ...]
lbrsl group rsl pri_slot sec_slot
[sec_slot...]
where:
lb specifies a load balancing group.
rsl specifies a resilient server link group.
RxIPAddr is a dedicated IP address for the load balancing
group
pri_slot is the PCI slot number of the primary NIC.
sec_slot is the PCI slot number of a secondary NIC.
Example
lbrsl group lb addr 192.1.1.100 10001
10002
lbrsl group rsl 10001 10002
Default None