Filter
Top Products
Maintaining Groups 109
help
This command displays the syntax for the DynamicAccess
server features commands.
link timeout
When a group is being created, the software waits the
number of seconds specified by this command for the
link/topology check to finish and then displays timeout
information.
probe interval
This command sets the probe packet interval. If no
argument is specified or the specified argument is invalid,
the current value is displayed. Otherwise, the new value
is displayed.
Syntax
lbrsl display status [pri_slot]
where:
pri_slot is the PCI slot number of the primary NIC in the
group for which information is to be displayed. If this
parameter is not specified, information for all groups is
displayed. An example of the type of information
displayed follows:
Group NNN (LB group)
Primary board id: Original NNN, Current NNN
Load balancing on incoming IP packets: Enabled; IP Rx
Addr: NN.NN.NN.NN
Primary node address: XX:XX:XX:XX:XX:XX
Timeout values in seconds: send NNN, receive NNN,
wait NNN, link NNN
Probe Interval: NNN seconds
Slot number NNN (Active), Node Address:
XXX:XXX:XXX:XXX:XXX:XXX
Example
lbrsl display status 10001
Syntax
lbrsl help
Syntax
lbrsl link timeout seconds
where:
seconds is the time in seconds.
Example
lbrsl link timeout 10
Default 5