Filter
Top Products
4-4 C
HAPTER
4: C
ONFIGURATION
4 To change the current parameters, type
C
.
The Change Parameters menu appears:
5 Type the number or letter for the parameter you want to change.
Table 4-1 describes each parameter and the choices available. More
detailed descriptions of each parameter follow this table.
6 When you are finished changing firmware configuration parameters,
press the Escape key to return to the Firmware Configuration Utility
menu.
7 Press the Escape key again to exit to the monitor prompt.
8 Press the reset switch or turn off the server to exit monitor mode.
Current Parameters:
1. Console baud rate 9600
2. Console port 0
3. Continuous self-test Disabled
4. Auto-reboot Reboot only
5. Monitor Disabled
6. Initial boot source Floppy then Network
7. Number of reboots 00
8. Network boot string _cs200
9. Boot retries Try Forever
A. Boot protocol SLP
P. Printer setup menu
S. System default configuration menu
esc Return to previous menu
Table 4-1 Firmware Configuration Parameters
Parameter Values
1. Console baud rate 0. 110
1. 300
2. 1200
3. 2400
4. 9600
*
2. Console port 0
*
–9
3. Continuous self-test d - Disable
*
e - Enable
CS2500BookFile : Configuration Page 4 Thursday, December 11, 1997 10:44 AM