Filter
Top Products
Installing a WX Switch 33
5 Lift the WX switch into position in the equipment rack.
WARNING: To prevent the WX switch from slipping, do not release the
switch until all the rack-mount screws are tight.
6 Insert the bottom rack-mount screws into the bracket flanges to secure
the WX switch to the equipment rack, then insert the top screws.
7 Do one of the following:
If you are installing a second power supply into the switch, go to
“Installing a Power Supply in a WX4400 Switch” on page 34.
If you are ready to turn on power, go to “Powering On a WX Switch”
on page 37.
Tabletop Installation
1 On a clean work surface with no debris, carefully turn the WX switch
upside down.
2 Wipe the four placement locations for the rubber feet to clear away any
oil or dust. The location areas are marked by X’s.
3 Attach the four rubber adhesive feet over the X’s.
4 Turn the WX switch right-side up, and place the switch in position on the
table.
5 Do one of the following:
If you are installing a second power supply into the switch, go to
“Installing a Power Supply in a WX4400 Switch” on page 34.
If you are ready to turn on power, go to “Powering On a WX Switch”
on page 37.