Filter
Top Products
1-7
Enabling Logging for Network Management
Follow these steps to enable logging for network management:
To do… Use the command… Remarks
Enter system view
system-view
—
Enable logging for network
management
snmp-agent log { set-operation |
get-operation | all }
Optional
Disabled by default.
Use the display logbuffer command to view the log of the get and set operations requested by the
NMS.
Displaying and Maintaining SNMP
To do… Use the command… Remarks
Display the SNMP information
about the current device
display snmp-agent sys-info [ contact
| location | version ]*
Display SNMP packet statistics
display snmp-agent statistics
Display the engine ID of the
current device
display snmp-agent { local-engineid |
remote-engineid }
Display group information
about the device
display snmp-agent group
[ group-name ]
Display SNMP user information
display snmp-agent usm-user
[ engineid engineid | username
user-name | group group-name ]
Display Trap list information
display snmp-agent trap-list
Display the currently configured
community name
display snmp-agent community [ read
| write ]
Display the currently configured
MIB view
display snmp-agent mib-view
[ exclude | include | viewname
view-name ]
Available in any view
SNMP Configuration Examples
SNMP Configuration Examples
Network requirements
z As shown in Figure 1-2, an NMS and Switch A (SNMP agent) are connected through the Ethernet.
The IP address of the NMS is 10.10.10.1 and that of the VLAN interface on Switch A is 10.10.10.2.