Filter
Top Products
1-11
To do… Use the command… Remarks
Configure the probe timeout
time
timeout time
Optional
By default, a probe times out in
three seconds.
Configure the type of service
tos value
Optional
By default, the service type is
zero.
Configure the number of test
packets that will be sent in each
jitter probe
jitter-packetnum number
Optional
By default, each jitter probe will
send 10 packets.
Configure the interval to send
test packets in the jitter test
jitter-interval interval
Optional
By default, the interval is 20
milliseconds.
Start the test
test-enable
Required
Display test results
display hwping results
[ admin-name operation-tag ]
Required
You can execute the command
in any view.
6) Configuring SNMP test on HWPing client
Follow these steps to configure SNMP test on HWPing client:
To do… Use the command… Remarks
Enter system view
system-view
—
Enable the HWPing client
function
hwping-agent enable
Required
By default, the HWPing client
function is disabled.
Create a HWPing test group
and enter its view
hwping administrator-name
operation-tag
Required
By default, no test group is
configured.
Configure the destination IP
address
destination-ip ip-address
Required
By default, no destination
address is configured.
Configure the source IP
address
source-ip ip-address
Optional
By default, no source IP
address is configured.
Configure the source port source-port port-number
Optional
By default, no source port is
configured.
Configure the test type
test-type snmpquery
Required
By default, the test type is
ICMP.
Configure the number of
probes per test
count times
Optional
By default, each test makes
one probe.