Filter
Top Products
4 78-9000-0120-3-A
Introduction
The Dynatel
™
1420EZ Station consists of the following items;
Dynatel1.
™
1420EZ Stand: Writing stand that can hold up to ten Ball or ten Near Surface or ten Disk iD-Markers in pre-
allocated slots.
Dynatel2.
™
1420EZ Writer: iD-Marker reading and writing unit
Dynatel3.
™
PCTools: Software program that works with the 1420EZ Writer to provide an easy solution for writing up to
ten iD-Markers (of the same type/frequency) at one time utilizing user data templates which are created using a PC,
and the Dynatel
™
PCTools software program.
Initial Set-up
Dynatel
™
1420EZ Stand Assembly
NOTE: Dynatel
™
1420EZ Stand Assembly Instructions are also included in the shipping box.
The Dynatel
™
1420EZ Stand consists of six (6) components (identified in illustration below);
One (1) Upper level iD-Marker holding traya.
One (1) Lower level iD-Marker holding trayb.
One (1) Stand stability holding trayc.
Three (3) Stand legsd.
Assembly of components
Slide “Item C” slot into the lower slot of one (1) “Item 1.
D” component.
Note: the lower slot in the “Item D” component is farther
from the end of “Item D” than the upper slot. (See
illustration.)
Slide “Item B” slot into the middle slot, and “Item A” 2.
slot into the top slot, of the “Item D” component.
Note: It is imperative that the color dot labels on the top
surfaces of “Item C”, “Item B” and “Item A” line up.
Slide the second (2nd) and third (3rd) “Item D” 3.
components into the appropriate slots on “Item A”, “Item
B” and “Item C”.
m Caution
To reduce the risks associated with falling/impact due to Stand Assembly break down:
DO NOT sit on, or over load, the Stand Assembly.•