Filter
Top Products
Telnet Management
Telnet is done over the network. You can manage the switch via Telnet. First you have
to assign a unique IP address to the switch, then you can use the Telnet Management
method.
Follow these steps to manage the Switch
1. Assign an IP address to the switch
Run Telnet (e.g., telnet 192.168.168.168 , which is the factory default values for the
HomePNA Switch)
2. Log into the switch
The Log In figure displays the following messages. Before you start a management
session, enter the password required.
Default: No password is required. Press Enter to log in for the first time. It is
recommended that you set a password for security and management purpose.
Version 2.24
Managed HomePNA Switch
Admin password :
command>
help or ?
The following menu lists the keystroke and typographic conventions available on the
Switch.
command>help
Version 2.24v
===========================================================
Help Show this message
Show Displays active configuration
- 33 -