Filter
Top Products
Installing the VDSL Switch and Splitter
3-8
3. Check the front-panel LEDs as the switch is powered on to be sure the Power
LED is lit. If not, check that the power cable is correctly plugged in. The switch
will automatically select the setting that matches the connected input voltage.
Therefore, no additional adjustments are necessary when connecting it to any
input voltage within the range marked on the front panel.
4. The switch performs a self-diagnostic test upon power-on.
Note: The unit supports a “hot remove” feature which permits you to connect or
disconnect network cables without powering off the unit and without disrupting
the operation of the devices attached to the unit.