Filter
Top Products
Chapter 2 41
Main
The Main screen allows the user to set the system time and date as well as enable and disable boot option
and recovery.
NOTE: The screen above is for your reference only. Actual values may differ.
The table below describes the parameters in this screen. Settings in boldface are the default and suggested
parameter settings.
NOTE: The sub-items under each device will not be shown if the device control is set to disable or auto. This is
because the user is not allowed to control the settings in these cases.
Parameter Description Format/Option
System Time Sets the system time. The hours are displayed with 24-
hour format.
Format: HH:MM:SS
(hour:minute:second)
System Date Sets the system date. Format MM/DD/YYYY
(month/day/year)
System Memory This field reports the memory size of the system.
Memory size is fixed to 3071 MB.
N/A
Video Memory
Shows the video memory size. VGA Memory size=32 MB
N/A
Quick Boot Allows startup to skip certain tests while booting,
decreasing the time needed to boot the system.
Option: Enabled or
Disabled
Network Boot Enables, disables the system boot from LAN (remote
server).
Option: Enabled or
Disabled
F12 Boot Menu Enables, disables Boot Menu during POST. Option: Disabled or
Enabled
D2D Recovery Enables, disables D2D Recovery function. The function
allows the user to create a hidden partition on hard disc
drive to store operation system and restore the system
to factory defaults.
Option: Enabled or
Disabled
SATA Mode Control the mode in which the SATA controller should
operate.
Option: AHCI Mode or IDE
Mode
InsydeH20 Setup Utility Rev. 3.5
Information Main
Advanced Security Power Boot Exit
Item Specific Help
System Time
[13:04:04]
This is the help for the
System Date [04/21/2008] hour field. Valid range
is from 0 to 23.
Total Memory 3017 MB INCREASE/REDUCE : F5/F6
Video Memory [32MB]
Quick Boot [Enabled]
Network Boot [Enabled]
F12 Boot Menu [Disabled]
D2D Recovery [Enabled]
SATA Mode [ACHI]
F1 Help
↑↓
Select Item F5/F6 Change Item F9 Setup Default
ESC Exit
←→ Select Menu Ente
r
Select
X
Submenu F10 Save and Exit