Filter
Top Products
Chapter 2 31
On chip SATA Enable On chip SATA. Option: Enabled or Disabled
SATA Class ID Select the SATA Class ID. Option: IDE-ACHI Class,
HyperFlash Class, IDE-HyperFlash
Class, IDE Native Mode, Raid Class,
ACHI Class, or IDE Legacy Mode
SATA IDE
Combined mode
Set SATA IDE Combined mode. Option: Disabled or Enabled
PATA Channel
Config
Set the SATA channel as Primary or
Secondary channel.
Option: SATA as primary or SATA
as secondary
ACHI ROM
POST delay
Select SATA option ROM POST delay. Option: Disabled, 7, 6, 5, 4, 3, 2, or
1 second(s) delay
USB Host
Controller
Enable or disable USB hardware. Option: Enabled or Disabled
Legacy USB
Support
Enable support for Legacy Universal Serial
Bus.
Option: Enabled or Disabled
Option ROM
Placement
Determines which peripheral devices can
be booted.
NOTE: Changes to this setting can cause
the system to halt during boot.
Option: Disabled, Temporary, or
E000 Extend
Large Disk
Access Mode
Set the Large Disk Access mode. Different
O/S require different drive geometry
representations. Select Other for UNIX,
Novell NetWare, or other O/S.
Option: DOS or Other
Installed O/S Set the most commonly used O/S on the
system.
Option: Other, Win2000, WinMe,
Win98, or Win95
Reset
Configuration
Data
Clear Extended System Configuration Data
(ESCD) area.
Option: No or Yes
Processor
Assisted
Virtualization
Enable the hardware visualization support. Option: Enabled or Disabled.
Parameter Description Submenu Items