Filter
Top Products
26
English
Note: "H. Position", "V. Position", "Frequency" and "Tracking" functions
are not supported under DVI or Video mode.
Note: "Sharpness" functions is not supported under DVI and Computer
mode.
Note: "Signal Type" function is only for HDMI or SCART connector.
Front-Ceiling
• When you select this function, the projector inverts the image for
ceiling-mounted projection.
Rear-Desktop
• When you select this function, the projector reverses the image so
you can project from behind a translucent screen.
Rear-Ceiling
• When you select this function, the projector reverses and inverts
the image at same time. You can project from behind a
translucent screen with ceiling mounted projection.
H. Position
(Horizontal
position)
• Press to move the image left.
• Press to to move the image right.
V. Position
(Vertical position)
• Press to move the image down.
• Press to move the image up.
Frequency "Frequency" changes the projector's refresh rate to match the
frequency of your computer’s graphics card. If you can see a vertical
flickering bar in the projected image, use this function to make the
necessary adjustments.
Tracking Synchronizes the signal timing of the projector with the graphics card.
If you experience an unstable or flickering image, use this function to
correct it.
Sharpeness Adjusts the sharpness of the image.
• Press to decrease the sharpness.
• Press to increase the sharpness.
Signal Type Select signal type from RGB, YCbCr or YPbPr source.