Filter
Top Products
PANEL PC 1000 All-in-One PANEL PC User’s Manual
System Installation
17
3.13 System O/S and Software Installation
The PANEL PC 1000 is not equipped with any operating system. It
builds in a 2.5” HDD and 1.5MB Solid State Disk as memory storage
device. As both devices are built in the system chassis, to load any
O/S or application software into the computer, an external device is
needed to act as a bridge. There are three major ways to load
software into the system.
1.
Use an external FDD: Attach a 3.5” FDD to the external
FDD port via the provided external FDD cable.26-pin FDD
connector must be plugged into the system FDD
connector; the 34-pin standard 3.5” FDD signal connector
and the 4-pin FDD power connector are connected to the
standard 3.5” FDD. Then, configure the system BIOS setup
and insert a 3.5” disk containing necessary software and
start the installation.
2.
Use Ethernet: If the Ethernet BOOTROM is already included
in the system, the user can boot up the system via
BOOTROM and download system O/S or application
software from the net.
3.
Use External CD-ROM/ HDD: When using an external
CD-ROM or HDD for software installation on P PANEL PC
1000 an optional P-IDE device is needed. The P-IDE device
is a converter to convert the parallel port to the IDE
interface.