99
Hardware Requirements for R310
SATA RAID
Your system needs to have at least two SATA hard drives installed to
create a RAID array. A single hard drive is treated as JBOD and is
insufficient to create a disk array.
SATA RAID POST information
When the server boots up, POST information displays connected SATA
HDD information, array information, and SATA JBOD information.
SATA HDD information includes:
• attached port ID
•HDD model
• firmware version
• drive capacity
• drive status
Array information includes:
• array RAID level
• port
• drive models
• drive capacities
Server BIOS settings
Your system’s BIOS settings must be modified to enable SATA RAID.
Follow the steps below to change the BIOS settings and enable RAID
configuration.
1 Enter the BIOS Setup utility by pressing F2 when prompted during
system startup. See “Entering BIOS setup” on page 60 for more
information.
BB!S421!.!FO/cppl!!Qbhf!::!!Gsjebz-!Nbsdi!23-!3115!!5;1:!QN