Filter
Top Products
Appendices
34
English ...
Troubleshooting
If you experience trouble with the projector, refer to the
following information. If the problem persists, please
contact your local reseller or service center.
Problem: No image appears on screen.
Ensure all the cables and power connections are correctly and se-
curely connected as described in the “Installation” section.
Ensure the pins of connectors are not crooked or broken.
Check if the projection lamp has been securely installed. Please
refer to the “Replacing the lamp” section.
Make sure you have removed the lens cap and the projector is
switched on.
Ensure that the “Hide” feature is not enabled.
Problem: Partial, scrolling or incorrectly displayed image.
Press the “Resync” button on the Remote Control.
If you use a PC:
If the resolution of your computer is higher than 1024 x 768 (XD1250,
XD1250D)/800 x 600 (XD1150, XD1150D). Follow the steps outlined
below to reset the resolution.
For Windows 3.x:
1. In the Windows Program Manager, click the “Windows Setup”
icon in the Main group.
2. Verify that your display resolution setting is less than or equal to
1024 x 768 (XD1250, XD1250D)/800 x 600 (XD1150, XD1150D).
For Windows 95, 98, 2000, XP:
1. Open “My Computer” icon, the “Control Panel” folder, and then
double click on the “Display” icon.
2. Select the “Setting” tab.
3. In the “Desktop Area” you will fi nd the resolution setting. Verify
that the resolution setting is less than or equal to 1024 x 768
(XD1250, XD1250D)/800 x 600 (XD1150, XD1150D) resolution.
If the projector is still not projecting the whole image, you will
also need to change the monitor display you are using. Refer to
the following steps.
4. Follow the above steps 1-2. Click on the “Advanced Properties”
button.
5. Select the “Change” button under the “Monitor” tab .