Filter
Top Products
18
EXIT
MENU
UP
PAGE
OFF
POWER
ON
PIC-MUTE
DOWN
FOCUS
ENTER
FOCUS
SELECT
FOCUS
SELECT
3. Projecting an Image (Basic Operation)
Note on Startup screen (Menu Language Select screen)
When you first turn on the projector, you will get the Startup menu. This menu gives you the opportunity to select one
of the nine menu languages.
To select a menu language, follow these steps:
1. Use the SELECT
̆
or
̄
button to select one of the
nine languages from the menu.
2. Press the ENTER button to execute the selection.
After this has been done, you can proceed to the menu opera-
tion.
If you want, you can select the menu language later. (→ [Lan-
guage] on page 40)
NOTE: Immediately after turning on the projector, screen flicker may occur. This is normal. Wait 3 to 5 minutes until the lamp lighting
is stabilized.
When the [Lamp mode] is set to [Eco], the LAMP indicator will light green.
If one of the following things happens, the projector will not turn on.
• If the internal temperature of the projector is too high, the projector detects abnormal high temperature. In this
condition the projector will not turn on to protect the internal system. If this happens, wait for the projector's internal
components to cool down.
• When the lamp reaches its end of usable life, the projector will not turn on. If this happens, replace the lamp.
• If the lamp fails to light, and if the STATUS indicator flashes on and off in a cycle of six times, wait a full minute and
then turn on the power.
ENTER
EXIT
MENU
UP
PAGE
OFF
POWER
ON
PIC-MUTE
DOWN
FOCUS