Filter
Top Products
42
Actiontec 54 Mbps Wireless DSL Gateway User Manual
43
Chapter 4 Using Advanced Setup
Specify a Static IP Address
Select this option if the ISP service is configured to use RFC 1483 Bridged or
Routed using a Static IP Address. Enter the IP Address, Subnet Mask, and Default
Gateway Address provided by the ISP in the “Broadband Connection via Static
IP Address” screen, which causes the IP address and routing information to termi-
nate at the Gateway, as opposed to the IP address and routing information being
bridged to terminate at the computer. This allows the use of the router capabilities
for the Local Area Network (LAN).
☞
Note: Contact the ISP if unsure of the proper configuration.
Encapsulation
If the Gateway is configured to obtain an IP address through DHCP or to specify a
static IP address, select the appropriate encapsulation option used by the ISP (RFC
1483 Bridged or RFC 1483 Routed).
☞
Note: Contact the ISP if unsure of the proper configuration.
Unnumbered Mode/VIP Mode
If a block of public static IP addresses was purchased from the ISP, select
Unnumbered Mode by clicking in the appropriate check box. Then, enter the IP
Address and Subnet Mask in the “Gateway Address” and “Unnumbered Subnet
Mask” text boxes below the “Unnumbered IP Address.” Click Next, then click Save
and Restart to make all changes permanent.