Adaptec 44300 Computer Drive User Manual


 
Appendix D: Using the AFU for DOS 75
Example
The following example shows a typical system response after a
VERIFY
command has been
performed:
A:\> AFU VERIFY /C 0
Adaptec Flash Utility V1.0-0 B1406
(c)Adaptec Inc. 1999–2005. All Rights Reserved.
Reading flash image file (Build 1406)
Controller #0: Adaptec ASC-48300
File: Checksum: 642C [VALID] (Build 1406)
File: Checksum: 642C [VALID] (Build 1406)
Verified Successfully
VERSION
The
VERSION
command displays version information about the flash components on a
HostRAID controller.
Command Syntax
The command syntax for the
VERSION
command is as follows:
AFU VERSION [/C<Controller ID>]
Command Switches
For details on the /C switch, see SAVE on page 73.
Example
The following example displays version information about all supported HostRAID
controllers:
A:\> AFU VERSION /C 0
Adaptec Flash Utility V1.0-0 B1406
(c)Adaptec Inc. 1999–2005. All Rights Reserved.
Version Information for Controller #0 (Adaptec ASC-48300)
ROM: Build 1406 [VALID]
AFU Command Line – Step-by-Step
This section provides step-by step instructions for updating the flash.
To update the flash using the AFU command line:
1 Shut down the computer.
2 Insert the bootable disk that contains the AFU utility.
3 Turn on the computer.
4 Enter the system setup utility and verify that your computer is set up to boot from the
bootable disk.