Filter
Top Products
iii
AMM-1570/1572 User’s Guide
Stock Number: 510526-00, Rev. B Page: iii
Print Spec Number: 492379-00
Current Date: 3/7/94 ECN Date: 3/8/94
Interactive FAX Service
The Adaptec Interactive FAX Service provides the latest online information about
Adaptec products and services. The Adaptec Interactive FAX Service is available 23
hours a day, seven days a week, at 408-957-7150.
Ordering Software and Cables
To order Adaptec software and SCSI cables, call 800-442-SCSI (7274), M–F: 5:00 a.m. to
6:00 p.m., Pacific Time.
Literature Hotline
To request additional documentation for Adaptec products, call 800-934-2766,
M–F: 5:00 a.m. to 6:00 p.m., Pacific Time.
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in residential installations. This equipment generates, uses, and can
radiate radio frequency energy, and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause interference to radio or television equipment reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the inter-
ference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Move the equipment away from the receiver
• Plug the equipment into an outlet on a circuit different from that to which the receiver is
powered
• If necessary, the user should consult the dealer or an experienced radio/television technician
for additional suggestions
CAUTION: Only equipment certified to comply with Class B (computer input/output devices,
terminals, printers, etc.) should be attached to this equipment, and must have shielded interface
cables.
Finally, any changes or modifications to the equipment by the user not expressly approved by the
grantee or manufacturer could void the user’s authority to operate such equipment.
Each AMM-1570/1572 host adapter is equipped with an FCC compliance label which shows only
the FCC identification number. The full text of the associated label follows:
This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference and (2) this device
must accept any interference received, including interference that may cause undesired
operation.