Filter
Top Products
Provisioning LTPH-UM-1049-02, Issue 2
16 January 9, 2002 H2TU-C-319 List 4E
Configuring the System
The Config menu (see Figure 6 below) allows you to make the following changes:
• Standard options (see “Making Changes to Standard and ADC Options” on page 16).
• ADC options (see “Making Changes to Standard and ADC Options” on page 16).
• Date and time (see “Setting Date and Time” on page 14).
• Master clear (see “Clearing the History, Alarm, and Event Log Screens” on page 33).
• Reset to factory default configuration (see “Resetting to Factory Defaults” on page 32).
Figure 6. Config Menu
Making Changes to Standard and ADC Options
Figure 7 and Figure 8 on page 17 show the Standard and ADC configuration options. Standard options are those
supported by HiGain HDSL2 units when connected to units from other vendors. ADC options are an extended set
of options that are only available when using HiGain units exclusively. For a description of each option and a list
of possible option settings, refer to Table 5 on page 18 and Table 6 on page 19. To make changes to these options:
1 Press to select the Config menu.
2 Use the and arrow keys to select Standard Options or ADC Options, then press .
3 Use the arrow keys to select an option.
4 Press the to cycle through the available settings for that option.
5 Press to activate your choice.
Monitor Performance Event Log Config Inventory Report Rlogon Help
+-----------------------+
| Standard Options -> |
| ADC Options -> |
| Test Mode -> |
| Date and Time -> |
| Master Clear |
| Set Factory Defaults |
+-----------------------+
ID: xxxx--xxxx--xxxx--xxxx 08/01/2001 06:38:12 H2TU-C System: OK
C
↑ ↓
ENTER
SPACEBAR
ENTER