Filter
Top Products
EVB7400
Chapter 3 Setup EVB7400 Environments
3.1 Ethernet 10/100 BASE-T Connector
Same connector and pin for both 10Base-T and 100 Base-Tx
< At the network interface card/hubs >
< At the cables >
RJ45 female connetor at the network interface cards and hubs
RJ45 male connector at the cable
Pin Name Descriptions
1 TX+ Tranmit Data+
2 TX- Tranmit Data-
3 RX+ Receive Data+
4 N/C Not Connected
5 N/C Not Connected
6 RX- Receive Data-
7 N/C Not Connected
8 N/C Not Connected
NOTE : TX & RX are swapped on hub
3.2 Connection Method for UTP Cable
RJ45 pins on EVB7400 is defined to Adapter side. So, you straight connect EVB7400 to hub through UTP cable. In this case, between
the EVB7400 and the Hub, the pin numbers correspond to each other.
Between the EVB7400 and the NIC which is on the Host PC, you have to connect each other through UTP cable which is crossover
patch cord.
User’s Manual V.0.10 13/36
Copyright © 2004 MCS LOGIC Limited. All rights reserved