Filter
Top Products
EVB7400
Chapter 5 Opennice32 Installation
5.1 OPENice32
The OPENice32 can also be connected with the EVB7400 as a debugging system for software applications development. OPENice32 is
a JTAG-based, nonintrusive, debugging system for ARM-based controllers or processors. JTAG provides the interface between a
debugger and the ARM-based controller development board.
To use the OPENice32, the following additional equipment are required:
- OPENice32
- 14-way ribbon cable
- 9-pin RS232 cable or parallel cable
- 5 V DC (Max. 3A) power supply
5.2 Connecting EVB7400 and PC
The OPENice32 should be connected to the EVB7400's JTAG Port (J3) via a 20-way cable, and to the host PC via a 9-pin RS232 serial
or parallel cable.
To power on the OPENice32, DC 5 V power supply is
required.
EVB7400
[Figure 7 ] C
ONNECTING WITH OPENICE32
5.3 Powering up the Board and OPENice32
We recommend that you power on the EVB7400 before the OPENice32 is powered on. In this way, the system initialization and memory
configuration for EVB7400 performed by the Boot Code can be completed first.
Otherwise, it may cause the failure of code download via JTAG.
User’s Manual V.0.10 20/36
Copyright © 2004 MCS LOGIC Limited. All rights reserved