Filter
Top Products
ADCP-50-304 • Issue 19 • June 1999 • Section 7: Operation
Page 7-15
© 1999, ADC Telecommunications, Inc.
Enter 7. Configuration Switch from the
Select Switch Action Menu to display:
Select Configuration
l. (11 Characters)
2. (11 Characters)
3. (11 Characters)
4. (11 Characters)
5. (11 Characters)
Ctrl X To Exit
(--) >
Enter the desired predefined
configuration: This entry displays:
Chassis No. XX xxxxxxxxxxx
Application Module # 0 1 2 3 4 5 6 7 8 9
10 11 12 13 14 15 Sw Status
This display is immediately followed by:
Switch to Displayed Configuration
1. Yes
2. No
Ctrl X To Exit
(2) >
Enter l. Yes or 2. No
Entry of 1. Yes displays
either xxxxxxxxxxx Application
Online followed by the Select Switch
Action Menu
or
Chassis No. XX Module # 0 1 2 3 4 5 6 7 8
9 10 11 12 13 14 15 Sw Status Failed Act
Command Action
Incomplete Retry Command?
1. Yes
2. No
Ctrl X To Exit
(2) >
Five selectable predefined chassis configurations,
each identified by a 11-character name.
Ctrl X – Redisplays the Select Switch Action Menu.
Similar to status display shown in Table 7-2,
except it shows the predefined configuration selected
before it actually reconfigures the chassis.
1. Yes – Reconfigures the chassis modules as displayed.
2. No – Redisplays the Select Switch action Menu to
allow selection of a different configuration.
Ctrl X – Redisplays the Select Switch Action Menu.
Reconfiguration occurred as commanded.
Switch status as defined in
Table 7-2
.
Switching actions have not occurred as commanded.
1. Yes – Reattempts last switch action.
2. No – Does not reattempt last switch action,
and redisplays the Select Switch Action Menu.
Ctrl X – Redisplays the Select Switch Action Menu.
Table 7-4. Change Switch Selection, continued
ACTION/DISPLAY DISPLAY DEFINITION