Filter
Top Products
61200.130L1-1 FSU User Manual 45
Chapter 6. DTE Port Configuration
Setting the IP address to 0.0.0.0 and setting the Mng DLCI to a
value not used by the attached frame relay device disables this
feature.
IP Address (IP ADDR)
Enter the FSU IP address. Each port capable of carrying IP traffic
has its own unique IP address. See the previous section, Guide-
lines for Configuring IP Addr, Subnet Mask, and Mng DLCI, for
more information.
IP Subnet Mask
Enter the subnet number assigned to the network formed by the
FSU and the other FRAD/routers across the frame relay net-
work. See the section, Guidelines for Configuring IP Addr, IP
Subnet Mask, and Mng DLCI, for more information.
Management DLCI (MNG DLCI)
Enter the management data link connection identifier. The
Management DLCI is a special DLCI used between the attached
DTE device and the FSU to carry SNMP and telnet packets to/
from the FSU on the DTE port. See the section, Guidelines for
Configuring IP Addr, Subnet Mask, and Mng DLCI, for more
information.
Protocol Address Table
DTE Port DLCI (PRT DLCI)
Enter the DTE port DLCI into the Protocol Address Table,
mapping it to the corresponding Network DLCI. If address
translation is not required, set to the value of the corresponding
network DLCI element.
Network DLCI (NET DLCI)
Enter the network port DLCI into the Protocol Address Table,
mapping it to the corresponding DTE Port DLCI. This element
should contain DLCI addresses obtained from the service
provider.
Edit Next Entry (NEXT key on front panel)
Edit the next entry in the address table.