Filter
Top Products
Unit Installation NetVanta 4300/4400 Series
46 Copyright © 2013 ADTRAN, Inc. 61200890E2-34R
4. UNIT INSTALLATION
The instructions and guidelines provided in this section cover hardware installation topics, such as wall
mounting/rack mounting the unit and installing option cards. These instructions are presented as follows:
• Mounting Options on page 47
• Supplying Power to the Unit on page 49
• Installing Dial Backup and Network Interface Modules on page 51
• Using a USB Cellular Modem with the NetVanta USB WWAN NIM on page 53
• Installing the NetVanta VPN Accelerator Card (included in P/N 4200368L1) on page 54
• Installing a SODIMM for Expandable Memory on page 55
• Installing a CompactFlash Card on page 57
For information on router configuration for a specific application, refer to the configuration guides provided on
the ADTRAN Support Community
. For details on the command line interface (CLI), refer to the AOS
Command Reference Guide. All other related documents are also available online at
http://supportforums.adtran.com
.
To prevent electrical shock, do not install equipment in a wet location or during an
electrical storm.
The NetVanta 4000 Series is intended to be installed, maintained, and serviced by
qualified service personnel only and should be installed in a restricted access location as
described in UL/IEC 60950-1.
Ethernet cables are intended for intrabuilding use only. Connecting an ADTRAN unit
directly to Ethernet cables that run outside the building in which the unit is housed will
void the user's warranty and could create a fire or shock hazard. To connect an ADTRAN
unit to Ethernet cables that run outside the building, ADTRAN's Ethernet Port Protection
Device (EPPD) (P/N 1700502G1) must be connected between the unit and the outside
plant cable. Use of any Ethernet protector other than ADTRAN's for this purpose will void
the user's warranty.