Filter
Top Products
Command Reference Guide Enable Mode Command Set
61200990L1-35E Copyright © 2005 ADTRAN 217
show ip pim-sparse [interfaces <interface> | neighbor | rp-map | rp-set |
state | traffic]
Use the show ip pim-sparse command to display Protocol Independent Multicast (PIM) configuration
information. Sparse mode or PIM-SM is a routing protocol used to establish and maintain the multicast
distribution tree. Routers can participate in the shared tree (RPT) rooted at the rendezvous point (RP)
router or the shortest-path tree (SPT) rooted at a multicast source. PIM-SM also establishes both shared
trees and shortest-path trees.
Syntax Description
interface <interface> Displays PIM-SM configuration and status information for a specific interface.
Type show ip pim-sparse interface ? to display a list of applicable interfaces.
neighbor Displays neighbor adjacency information.
rp-map Displays active group-to-RP mappings.
rp-set Displays list of statically configured RP candidates. The group address is
224.0.0.0/4 when no access group was applied to the rp-address command (see
rp-address <ip address> access-group <access-list-name> on page 1131).
Otherwise it is the name of the access group.
state Displays multicast route PIM state information.
traffic Displays active PIM-SM control traffic statistics.
Default Values
No default necessary for this command.
Applicable Platforms
This command applies to the NetVanta 2000 and 5000 and the Total Access 900 Series units.
Command History
Release 11.1 Command was introduced.
Usage Examples
The following example shows sample output from the show ip pim-sparse command:
>enable
#show ip pim-sparse
Global PIM Sparse Mode Settings
Join/Prune interval: 60, SPT threshold: 1