Filter
Top Products
Command Reference Guide Ethernet Interface Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 558
ip ospf
Use the ip ospf command to customize OSPF settings (if needed).
Default Values
dead-interval <seconds> 40 seconds
hello-interval <seconds> 10 seconds: Ethernet, point-to-point, Frame Relay, and PPP
retransmit-interval <seconds> 5 seconds
transmit-delay <seconds> 1 second
Applicable Platforms
This command applies to the NetVanta 300, 2000, 3000, 4000, and 5000 and Total Access 900 Series
units.
Command History
Release 3.1 Command was introduced.
Release 5.1 Command was expanded to include Ethernet sub-interfaces.
Syntax Description
authentication-key
<password>
Assigns a simple-text authentication password to be used by other routers
using the OSPF simple password authentication.
cost <value> Specifies the OSPF cost of sending a packet on the interface. This value
overrides any computed cost value. Range: 1 to 65,535.
dead-interval
<seconds> Sets the maximum interval allowed between hello packets. If the maximum
is exceeded, the neighboring device is assumed to be down.
Range: 0 to 32,767.
hello-interval
<seconds> Specifies the interval between hello packets sent on the interface.
Range: 0 to 32,767.
message-digest-key
<keyid> md5 <key>
Configures OSPF Message Digest 5 (MD5) authentication (16-byte max)
keys.
priority
<value> Sets the OSPF priority. The value set in this field helps determine the
designated router for this network. Range: 0 to 255.
retransmit-interval
<seconds>
Specifies the time between link-state advertisements (LSAs).
Range: 0 to 32,767.
transmit-delay
<seconds> Sets the estimated time required to send an LSA on the interface.
Range: 0 to 32,767.