Filter
Top Products
Command Reference Guide Ethernet Interface Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 555
ip mcast-stub downstream
Use the ip mcast-stub downstream command to enable multicast forwarding and IGMP (router mode) on
an interface, and to place it in multicast stub downstream mode. Use the no form of this command to
disable.
Syntax Description
No subcommands.
Default Values
By default, this command is disabled.
Applicable Platforms
This command applies to the NetVanta 300, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 7.1 Command was introduced.
Functional Notes
This command is used in IP multicast stub applications in conjunction with the ip mcast-stub
helper-address and ip mcast-stub upstream commands. Downstream interfaces connect to segments
with multicast hosts. Multiple interfaces may be configured in downstream mode; however, interfaces
connecting to the multicast network (upstream) should not be configured in downstream mode. Interfaces
configured as downstream should have the lowest IP address of all IGMP-capable routers on the
connected segment in order to be selected as the designated router and ensure proper forwarding. Refer
to
ip mcast-stub helper-address <ip address> on page 387 and ip mcast-stub upstream on page 557 for
more information.
Usage Examples
The following example enables multicast forwarding and IGMP on the interface:
(config)#interface eth 0/1
(config-eth 0/1)#
ip mcast-stub downstream