Filter
Top Products
USB Mode Connection
Hardware installation
1. Connect your INTEGRAL LAN to the computer using the supplied USB cable
2. Connect the supplied power pack to any available AC socket and your INTEGRAL LAN.
3. Switch on the power and your enclosure is ready to use.
Note: In order to reach USB 2.0 speed, you must have a motherboard or host adapter card that has
USB 2.0 support. This device will auto sense the speed of your USB port and adjust between USB 1.0
and USB 2.0 speed.
CAUTION! Do not connect USB cable and Ethernet cable at the same time.
USB Mode Setup
INTEGRAL LAN
Computer
AC Power
USB Cable
USB Connection
NOTE:enclosed CD driver disk is not required
for the installation
1.
When the USB External Drive is used for the
first time your PC system will detect a USB2.0
Storage Device and automatically install the
drivers for [USB Mass Storage Device] from
the installed system files.
2.
When the PC system finishes installing the
USB mass storage device driver, double click
on [My Computer]. A drive Disk is added
after few seconds, this is the INTEGRAL LAN
drive.
NOTE:
This INTEGRAL LAN drive is supported by Mass Storage Device within WIN Me/2000/XP system directly.
You do not need to install any drivers. If the external hard disk is a new disk drive which has not been
partitioned, please refer to the Partition the External Hard Disk chapter to prepare your USB2.0
external disk.
Software installation
Windows Me / 2000 / XP
19