AT-S63 Management Software Features Guide
Section III: Snooping Protocols 231
Configuring the Feature
The procedures in this section illustrate how to use the standard
commands and the AlliedWare Plus commands to configure the switch for
IGMP snooping querier. The procedures configure the settings for switch 1
in Figure 25 on page 228.
To configure the feature with the standard commands:
1. To create the routing interface:
add ip interface=vlan1-0 ipaddress=149.123.48.2
mask=255.255.255.0
2. To enable IGMP snooping:
enable igmpsnooping
3. To enable IGMP snooping querier and apply it to the Default VLAN:
set ip igmp querier enable vlan=1
4. To confirm the routing interface:
show ip interface
Figure 27. SHOW IP INTERFACE Command
---------------------------------------------------
Interface IPAddress NetMask RipMet
---------------------------------------------------
eth0 0.0.0.0 0.0.0.0 1
vlan1-0 149.123.48.2 255.255.255.0 1