Filter
Top Products
Chapter 2: Installation
60
Protection Against Electrostatic Discharge (ESD)
Proper ESD protection is required when handling the SwitchBlade x3112
line cards and power supplies. You need properly grounded using wrist or
foot straps to eliminate the risk of ESD damage to the equipment.
Caution
Electrostatic Discharge (ESD) can damage components on the
SwitchBlade x3112 line cards and power supplies. Insure that
proper ESD procedures are followed during installation.
1. Verify that the chassis is electrically connected to earth ground.
2. Wear an ESD-preventive device such as a foot strap or wrist strap,
ensuring that it makes good contact with the user’s skin.
If a foot strap is used, the floor must be ESD conductive.
3. Connect the clip from the ESD-preventative device to the ESD socket
on the lower right side of the AT-SBx3112 Chassis front panel or an
unpainted surface of the frame or rack as displayed in Figure 32. This
ensures that unwanted ESD voltages safely flow to ground.
Figure 32. ESD Socket
1855
ESD
7
9
11