Filter
Top Products
MULTI-TASKER
13
24. [G]
This command is used to request group data.
With the command, the user can identify which
input or output of a particular group is on.
Command Format: [GkUi]
Gk = group number (k = # from 1-9)
Ui = unit number (i = # from 0-9)
Example:
In unit ID0, if group 1 has DA Cards with
outputs 1 and 2 on, while group 2 has SW
Cards with input 2 on:
[G1]: will return feedback as ON12 G1U0.
[G2]: will return feedback as ON2 G2U0.
25. [RD]
This command displays the members in each
group.
Command Format: [RDGkUi]
Gk = group number (k = # from 1-9)
Ui = unit number (i = # from 0-9)
member = C1 - C19 (card 1 to 19)
(1-8 for MT100-101 or 1-4 for MT100-106)
Example:
The cards in slots 1, 2 and 19 are part of group
5 in unit 1. Read the member data for group 5
of unit 1, by sending the command [RDG5U1].
The system will return feedback as follows:
C1C2C19 G5U1.
7.3 SUMMARY OF COMMANDS
1) [VER] Receives software version
2) [Ci] Receives status of the card
3) [CLR] Resets card to defaults
4) [ + ] Increments and Decrements
[ - ] selected commands
5) [HPOS] Set the Horizontal Position
6) [HPOS] Adjust/Read Horiz. Position
7) [VPOS] Set the Vertical Position
8) [VPOS] Adjust/Read Vert. Position
9) [HSIZE] Set the Horizontal Size
10) [HSIZE] Adjust/Read Horizontal Size
11) [VSIZE] Set the Vertical Size
12) [VSIZE] Adjust/Read the Vertical Size
13) [QZOOM] Zoom to a quadrant
14) [QZOOM] Adjust Zoom by quadrant
15) [BRIG] Set Brightness level
16) [BRIG] Adjust/Read Brightness
17) [SHARP] Set Sharpness level
18) [SHARP] Adjust/Read Sharpness
19) [OUT] Select NTSC or PAL format
20) [BAR] Video or test pattern
21) [HELP] Display available commands
22) [WR] Group multiple cards
23) [CLR] Clear group configurations
24) [G] Request group data
25) [RD] Display group members
TROUBLESHOOTING GUIDE 8
We have carefully tested and have found no
problems in the supplied MT106-100; however, we
would like to offer suggestions for the following:
8.1 LED IS NOT LIT
Cause 1: Card cage is not plugged in.
Solution: Plug card cage in. If the LED lights,
the problem is solved. If the LED is
still not ON, see Cause 2.
Cause 2: Card is not plugged in all the way.
Solution: Push the card in all the way. If the
LED is still not ON, see Cause 3.