Filter
Top Products
MULTI-TASKER
8
Example:
One MT106-100 card is in slot #2 of unit 3.
Sending the command [VERC2U3] to the
Multi-Tasker™ Basic Enclosure will yield the
following feedback:
MT106-100 690-0129-004
MT106-100 = card type
690-0129-004 = software version
2. [C]
This command receives the status of the card.
Command Format: [CnUi]
Cn = card ID (n = a slot # from 1 to 19)
(1-8 for MT100-101 or 1-4 for MT100-106)
Ui = unit id (i = 0 to 9) (refer to the MT100-100
user’s guide for explanation)
Example:
There is one MT106-100 card in slot #2 of unit
3 set for NTSC outputs. Sending the command
[C2U3] to the Multi-Tasker™ will provide the
following feedback:
INPUT:640x480; OUTPUT:NTSC C02
INPUT:640x480 = Input resolution
OUTPUT:NTSC = Output mode
C02 = card is in slot 2
If there is no card in slot #2 of unit 3, sending
the [C2U3] command will not return any
feedback from the card.
3. [CLR]
This command resets the card configuration to
factory defaults.
Command Format: [CLRCi]
Ci = card ID (n = a slot # from 1 to 19)
(1-8 for MT100-101 or 1-4 for MT100-106)
Example:
There is an MT106-100 in slot 4 of unit 0. All
controls are set to various levels and the output
is in PAL mode. Sending the command
[CLRC4] will set the level controls to their
default values and place the card in NTSC
format.
4. [ + ] or [ - ]
These commands allow the user to increase or
decrease the selected attribute value. They
must be used immediately following one of the
following STATUS commands.
STATUS
Command
MIN
Value
MAX
Value
Default
Value
[ HPOSCi ] 0 20 10
[ VPOSCi ] 0 20 10
[ HSIZECi ] 0 20 10
[ VSIZECi ] 0 20 13
[ BRIGCi ] 1 4 1
[ SHARPCi ] 1 8 5
[ QZOOMCi ] 0 4 0
Attempting to cycle past the minimum or
maximum values will have no effect on the
attribute's value. Only QZOOM will cycle back
around through its range of values.
Any command other than [ + ] or [ - ] will reset
the previous selection and the STATUS
command will need to be reissued.
Example:
There is an MT106-100 in slot 4 of unit ID 2.
The current Horizontal Position is set to a value
of 10. Use the [ + ] and [ - ] controls to find the
best horizontal position. Starting from 10, first
increment the value to 12.
Next, decrement the value back down to 8 for
the best picture.
[HPOSC4U2] 10 [ + ][ + ][ - ][ - ][ - ][ - ]
[HPOSC4U2] = STATUS/Current value
10 = Feedback of current value
[ + ][ + ] = Increment twice to 12
[ - ][ - ][ - ][ - ] = Decrement 4 times to 8
[HPOSC4U2] = STATUS/Current Value
8 = Feedback of new value