Filter
Top Products
MULTITASKER
400-0197-006
16
{WRS8=RUPC4} //Ramp Up
{WRK8=8,108,0,0,0} //Press= start, release= stop
{WRS10=RDNC4} //Ramp Down
{WRK10=10,108,0,0,0} //Press= start, release= stop
{WRS108=RSTC4} //STOP RAMPING
{SETVK8} //Set key 8 as volume key
{WRLK8=VOL_UP} //Define Key 8 Label
{SETVK10} //Set key 8 as volume key
{WRLK10=VOL_DN} //Define Key 8 Label
[RAMP=10C4] //Set the ramp rate.
29. [RUP]
This command ramps the output volume to its
maximum level at the rate defined using the
[RAMP] command.
Command Format: [RUPCn]
Cn = Card ID (n = # from 1 to max slots)
Example:
Ramp the volume on Output 1 from 10 to the
maximum of 32 for C4. Send the commands
[SEL1C4] then [RUPC4] and the system will
respond with the following feedback:
[11][12][13][14]…[32]
30. [RDN]
This command ramps the output volume down
to a level of 00 at a rate defined using the
[RAMP] command.
Command Format: [RDNCn]
Cn = Card ID (n = # from 1 to max slots)
Example:
Ramp the volume on Output 1 from a starting
level of 32 down to 00 for C4. Send the
commands [SEL1C4] then [RDNC4] and the
system will respond with the following feedback:
[31][30][29]…[00]
31. [RUPm]
This command ramps up the volume for the
specified output. The ramping continues to its
maximum level at the rate defined using the
[RAMP] command. The ramping may be
stopped at any time using the [RST] command.
Command Format: [RUPmCn]
Cn = Card ID (n = # from 1 to max slots)
m = Output No. (n = # from 1 to 8)
Example:
Ramp the volume for Output 2 from a starting
level of 10 to the maximum level of 32 for C4.
Send the command [RUP2C4] and the system
will respond with the following feedback:
[11][12][13][14]…[32]
32. [RUPm=xx]
This command ramps a specified output’s
volume to a user defined level at a rate defined
using the [RAMP] command.
Command Format: [RUPm=xxCn]
m = Output No. (m = # from 1-8)
xx = Stop Level (xx = # from 01-32)
Cn = Card ID (n = # from 1 to max slots)
Example:
Ramp the volume on Output 7 from a starting
level of 1 to a level of 20 for C4. Send the
command [RUP7=20C4] and the system will
respond with the following feedback:
[02][03][04]…[20]
33. [RDNm]
This command ramps down the volume for the
specified output. The ramping continues to its
minimum level at the rate defined using the
[RAMP] command. The ramping may be
stopped at any time using the [RST] command.