Filter
Top Products
44 Operation
Chapter 3 - Using the Web Configuration Server
Click on the Save button before leaving the page to save the new settings. The new
settings will be applied after restarting the unit.
Click the
Set Codecs/Fax button to change codecs settings/priorities as
described in the following section.
Incoming CLIP The Calling Line Identity Presentation (Caller ID) option for the
telephone line. If On is selected, the Caller ID information of a
calling party in incoming calls will be displayed on a caller ID
display attached to the telephone line.
Caller ID can be restricted permanently using a customized .ini file.
The default is Off.
Keepalive Timeout (seconds) The interval of waiting for acknowledgement message from the
server. If Keep-alive timeout is sent from the network, it will override
the setting in the Voice Gateway. The interval for sending
Keep-alive registration messages from the Gateway is half the
configured value (600 seconds with the default timeout of 1200
seconds).
In case of registration problem, try changing the value to 1800
seconds.
The range is from 10 to 65535 seconds.
The default is 1200 seconds.
Ring signal [0 - 9] The Ring signal parameter provides a selection of 10 different ring
patterns (0-9) that the unit can use.
The default is 0.
Transport
(SIP model only)
Configure whether signaling shall use UDP or TCP. The default is
UDP.
Preferred codecs Displays the currently supported codecs, according to the defined
priorities.
Click the Set Codecs/Fax button to change codecs
settings/priorities.
NOTE: Click Save before clicking the Set Codecs/Fax button.
Otherwise, all configuration changes in the Telephone page will be
lost.
Table 3-6: SIP Configuration/H323 Telephone Page Parameters
Parameter Description