Filter
Top Products
Raid Introduction
58
Manually Creating an Array
The Define Array <3> option from the Main Menu allows users to begin the process of manually
defining the drive elements and RAID levels for one or multiple disk arrays attached to this
motherboard. Users will commonly create one or two drive arrays with the motherboard, though
the motherboard will support a maximum of four arrays
1
.
NOTE: For most installations, We recommends the <1> Auto Setup for easy disk array creation.
FastBuild (tm) Utility 1.xx (c) 1995-2000 Promise Technology, Inc.
[Define Array Menu]
Array No RAID Mode Total Drv Capacity(MB) Status
Array 1 Stripe 2 16126 Functional
Array 2 —— —— —— ——
Array 3 —— —— —— ——
Array 4 —— —— —— ——
[ Keys Available ]
Note: * — Bootable Array
[
↑
] Up [
↓
] Down [ESC] Exit [Enter] Select [Space] Change Boot Drive
1. To manually create an array from the Define Array Menu, use the arrow keys to highlight
the array number you wish to define, and press [Enter] to select.
2. The Define Array Definition Menu will next appear that allows drive assignments to the disk
array (see next page).
1
A user may use a single drive in either striping mode with system. In this rare scenario,
the motherboard will create an individual array ID but will offer conventional controller
performance, depending on the drive type. At a later time, a second drive can be added to
the array and the array re-created to support RAID 1 mirroring.