Filter
Top Products
14
(9) Primary IDE Connector (40-pin block): IDE1
This connector is for IDE hard disk ribbon cable connection. Connect the single plug
end to motherboard and the two plugs at other end to your hard disk(s). If you install
two hard disks, you must configure the second drive to Slave mode by setting its
jumpers accordingly. Please refer to the documentation of your hard disk for the
jumper settings.
(10) Secondary IDE Connector (40-pin block): IDE2
This connector connects to the another set of Master and Slave hard disks. Follow the
same procedure described for the primary IDE connector. You may also configure
two hard disks to be both Masters using one ribbon cable on the primary IDE
connector and another ribbon cable on the secondary IDE connector.
Pin 1
IDE1
Pin 1
IDE2
•
Two hard disks can be connected to any one of the connectors. The first HDD is referred
to as the “Master” and the second HDD is referred to as the “Slave”.
•
For best performance, we strongly suggest do not install CD-ROM or DVD-ROM drive
on the same IDE channel as a hard disk. Otherwise, the system performance on this channel
may drop.
2-6-2 Headers
(1) Line-Out, MIC Header (9-pin): AUDIO
This header connects to front panel line-out, MIC connector with cable.
Line-Out, MIC Headers
AUDIO
Pin 1
AUD
_
MIC
AUD
_
FPOUT
_
L
AUD
_
MIC
_
BIAS
AUD
_
FPOUT
_
R
HP
_
ON
AUD
_
GND
AUD
_
RET
_
L
AUD
_
RET
_
R
AUD
_
VCC
2
9
10