Filter
Top Products
English
21
3.9. Load Fail-Safe Defaults
ø Use this option to reset your BIOS settings to the system defaults. You should only use
this if you are encountering serious problems.
Please select <Y> and <Enter> to load Fail-Safe defaults. Once this is loaded, your
system may be slowed since this uses a minimal performance setting to allow stable
system running.
3.10. Load Optimized Defaults
ø Like the Fail-Safe mode above, this option loads the BIOS default settings, but runs the
system at optimal performance.
Please select <Y> and <Enter> to load optimized defaults.
3.11. Set User Password
ø Use this to set the password that is needed to either enter into the BIOS or to boot the
system. Entering in a blank field will disable the password.
Please input an 8 character long password and then select Enter. You will be required
to re-enter the password for confirmation. If you wish to remove the need for password
entry, leave the entry blank and then select Enter. BIOS will then display "PASSWORD
DISABLED". Once you have completed the password setting, you will need to go to
"Advanced BIOS Features" and select "Password Check" for setup of password check.
n CPU OverVoltage Control
Allows user to set the CPU voltage. (default:Auto)
Please note that by overclocking your system through the increase of the CPU voltage,
system instability or damage to the CPU may occur.
Options: Auto (automatic setting of CPU voltage as CPU required)
+5%, +7.5%, +10% (CPU voltage range)
n AGP OverVoltage Control
Allows user to set the AGP voltage. (default:Auto)
Please note that by overclocking your system through the increase of the AGP voltage,
system instability or damage to the AGP card may occur.
Options: Auto (automatic setting of AGP voltage at 1.5V)
+0.1V ~ +0.3V (AGP voltage range)
n DIMM OverVoltage Control
Allows user to set the DIMM voltage. (default:Auto)
Please note that by overclocking your system through the increase of the DIMM voltage,
damage to the memory may occur.
Options: Auto (automatic setting of DIMM voltage at 2.5V)
+0.1V ~ +0.3V (DIMM voltage range)