Filter
Top Products
Installation—Accessories
Temperature/Humidity Module 7
2. Thread a wire tie through the door holes,
skipping one hole in the middle.
If you have a temperature/humidity sensor,
place the sensor in the middle of the wire
tie, and pull the wire tie around a ridge on
the sensor casing.
If you have a temperature sensor, pull the
wire tie around the sensor cord, about 1/2-in
(1 1/4-cm) from the sensor.
3. Tighten and trim the wire tie.
4. To route the sensor cord, choose a location on
the inside of the door frame that is even with
the sensor.
5. Peel the backing off the adhesive side of a
cable mount, and press the cable mount firmly
to the inside of the door frame. Thread a wire
tie through the cable mount, and secure the
sensor cord with the wire tie. Tighten and trim
the wire tie
6. To secure the sensor cord, choose a location
near the middle of the door frame, and repeat
step 5.
aem0073a
aem0074a