Filter
Top Products
Page 5
2.0 Safety !
Caution!
CAUTION !
■ To reduce the risk of electric shock, disconnect the Uninterruptible Power
Source from the mains before installing a computer interface signal cable (when
used). Reconnect the power cord only after all signalling interconnections have
been made.
■ Connect the Uninterruptible Power Source to a two-pole, three-wire ground-
ing mains receptacle. The receptacle must be connected to appropriate branch
protection (fuse or circuit breaker). Connection to any other type of receptacle
may result in a shock hazard and may violate local electrical codes.
■ This Uninterruptible Power Source has an internal energy source (the battery)
that cannot be de-energized by the user. The output may be energized when the
unit is not connected to a mains supply.
■ To properly de-energize the Uninterruptible Power Source in an emergency,
move the I/O switch to the O (off) position and disconnect the power cord from
the mains.
■ Avoid installing the Uninterruptible Power Source in locations where there is
water or excessive humidity.
■ Do not allow water or any foreign object to get inside the Uninterruptible
Power Source. Do not put objects containing liquid on or near the unit.
■ To reduce the risk of overheating the Uninterruptible Power Source, avoid
exposing the unit to the direct rays of the sun. Avoid installing the unit near heat
emitting appliances such as a room heater or stove.
ENGLISH