Filter
Top Products
40
PORT 1 TEST
Port 1 is the serial data from pins 2 & 3 of the DB-9 which send data from the VSSI-Pro to a printer. Sending and receiving
data performance can be analyzed under the PORT 1 TEST sub-menu. Press the “Up” or “Down” button to move the
cursor to “PORT 1 TEST” and press “Set”. The following sub-menu will appear:
Figure 44: TEST/DEMO MODE Sub-Menu
Figure 45: PORT 1 TEST Sub-Menu
RECEIVE [ RX ] TEST
This checks if the VSSI-Pro is receiving data from the ATM serial interface. Press the “Up” or “Down” button to move the
cursor to “RECEIVE [ RX ] TEST” and press “Set”. The following display will appear (example only):
PROGRAMMING THE VSSI-PRO
VSSI-Pro VIDEO SERIAL ATM INTERFACE
Figure 46: RECEIVE [ RX ] TEST Display
TEST/DEMO MODE
The Test/Demo Mode provides you with several ways to test the VSSI-Pro and show its capabilities as an ATM interface.
There is no actual programming in this menu that you need to do now or settings that you would change. You will
probably only run the tests for troubleshooting purposes, and the demos would be helpful for demonstrating the VSSI-Pro
to a customer without actually having to access an ATM.
To access this section, press the “Up” or “Down” button to move the cursor to “TEST/DEMO MODE” and press “Set”. The
following sub-menu will appear:
RX BAUDRATE : 19200
TX BAUDRATE : 19200
PARITY : NONE
DATA BIT : 8
HANDSHAKING : OFF
RECEIVING :
PORT 1 TEST
PORT A TEST
PORT B TEST
DATA CAPTURE
ATM DEMO
VERSION ID
EXIT
RECEIVE [ RX ] TEST
TRANSMIT [ TX ] TEST
RX/TX TEST
BAUD RATE SCAN
EXIT
NOTE
""
""
"
The figures used in the test display settings are for example only. The settings for your
ATM will depend on the format chosen in the ATM SELECT menu.