Filter
Top Products
Installation & Setup
28
Precis SD Instruction Manual
Serial Control Device Startup
If you have not already done so, attach the serial control device to the CONTROL port on the enclosure
(see page 20) and open the control program.
AMX Control Devices
The Precis SD is compatible with a number of AMX control devices. For specific control programming
information, contact your AMX representative.
APControl 3.0
If you are using APControl 3.0, install and open the program. Follow the directions in the setup wizard.
From the Launchbar menu, select Views / CrossBar and click on the crosspoints to execute switches.
APWeb
For startup information, see the APWeb Server Module documentation.
HyperTerminal
When power is applied to the enclosure, HyperTerminal displays a short splash screen followed by
“Ready” (FIG. 16). The system is ready to disconnect the factory default switch and to execute a test
switch (see page 31). FIG. 16 shows an example of a short splash screen on power-up.
Precis SD models display advanced system information when the command ~scr! is entered
(see Appendix B on page 55).
For additional information on checking the firmware version, see page 57.
Note: AMX reserves the right to add to the contents of the splash screen at any time, without notice.
FIG. 16 Power-up splash screen in HyperTerminal
[1:Enclosure] AutoPatch Precis-500 v1.4.1 R
Ready
Firmware version