Filter
Top Products
3. Plug the provided power supply into P10 on the EZ-KIT Lite board.
Visually verify that the green power LED (LED6) is on. Also verify that
the two red reset LEDs (LED7 and LED8) go on for a moment and then
go off.
4. Connect the USB cable to an available full speed USB Port and to P7 on
the ADSP-21535 EZ-KIT Lite board.
2.4.5 Installing the EZ-KIT Lite USB Driver
The EZ-KIT Lite evaluation system can be installed on Windows 98 and
Windows 2000 and requires one full-speed USB port. Section 2.4.5.1 describes
the installation on Windows 98. Section 2.4.5.2 describes the installation on
Windows 2000.
2.4.5.1 Windows 98 USB Driver Installation
Before using the ADSP-21535 EZ-KIT Lite for the first time, the Windows 98
USB driver must first be installed.
To install the USB driver:
1. Insert the EZ-KIT Lite CD-ROM into the CD-ROM drive.
The connection of the device to the USB port will activate the Windows 98 “Add
New Hardware Wizard” as shown in Figure 2-2.
Figure 2-2: Add New Hardware Wizard Dialog Box
ADSP-21535 EZ-KIT Lite Evaluation System Manual
2-5