Filter
Top Products
APPENDIX A / ANNEXE A BROAD SCAN (HD/SDI)
PAGE 42
COMMAND RESPONSE COMMAND DESCRIPTION VALUE /VALEUR
COMMANDE RÉPONSE DESCRIPTION DE LA COMMANDE
TYPE
MIN MAX DESCRIPTION
COMMUNICATION COMMANDS / COMMANDES DE COMMUNICATION
ne ne Communication port selection Rd/Wr 0 1 0 = RS232 1 = LAN
nr nr Reset of the LAN parameters. Rd/Wr 0 1 1 = reset.
ns ns Store the LAN parameters. Rd/Wr 0 1 1 = store.
na na
IP address and port selection (for
modification)
Rd/Wr 0 3
0 = all IP address / ports
1 = IP local address / local port
2 = IP remote address / remote port
3 = IP gateway address.
nw nw
First byte of the address selected by the
na command.
Rd/Wr 0 255
nx nx
Second byte of the address selected by
the na command.
Rd/Wr 0 255
ny ny
Third byte of the address selected by
the na command.
Rd/Wr 0 255
nz nz
Forth byte of the address selected by the
na command.
Rd/Wr 0 255
np np
Number of the port (local or remote)
selected by the na command.
Rd/Wr 0 65500
local port: 10000 to 10999.
remote port: 0 to 65500.
nk nk netmask. Rd/Wr 0 24
Value = number of bit to 0 (from right).
example: 2 255.255.255.252
3 255.255.255.248
.............
8 255.255.255.0.............
24 255.0.0.0
nt TCP protocol selection. Rd/Wr 0 1 0 = UDP 1 = TCP
CONTROLS COMMANDS / COMMANDES DE CONTRÔLE
xU xU Device version
Rd
0 65535 The value is displayed in decimal and should be
converting in hexadecimal to obtain the version.
Example: xU262262 (dec) = 106 (hex)
106 = Version 1.06
ZT ZT Zoom type Rd/Wr 0 1 0 = Direct zoom
1 = Dynamic zoom
YL YL Auto frame Rd/Wr 0 1 0 = OFF 1 = ON
YK YK Front panel locking selection. Rd/Wr 0 3 0 = unlocks all buttons.
1 = locks Menu buttons.
3 = locks all buttons
ws ws Standby function (ON/OFF) Rd/Wr 0 1 0 = ON 1 = OFF
wt wt Stand by time Rd/Wr 0 8 0 = 0 second 1 = 1 min
2 = 5 min 3 = 10 min
4 = 15 min 5 = 30 min
6 = 60 min 7 = 90 min
8 = 120 min
wm wm Standby mode activation Rd/Wr 0 2 0 = Sync.loss 1 = Standby time
2 = Sync. loss + time
YE YE Erase memories Rd/Wr 0 1 1 = set all the parameters to the default value
(automatic reset).
YR YR Default value. Rd/Wr 0 1 1 = erase all memories (automatic reset).
NOTE: Rd = Read only command / Commande de lecture. Rd/Wr = Read and write command / Commande de lecture et d'écriture.