Filter
Top Products
11
• Complete Performance Verification. Refer to Initial Startup in the CTFLM/CTSLM
User Manual 990-5501.
• Replace/close the enclosure door(s).
• Indicator Lamp Replacement
Gently pry the lens off the indicator lamp using the tip of a screwdriver.
NOTE: Place a hand over the lens as it is loosened to ensure that the lens is not lost during the
procedure.
• Remove the spent lamp and replace it with a new one.
• Snap the lens back into place.
Euro Block Replacement
• Switch the utility circuit breaker OFF.
• Remove/open the enclosure door(s).
• Remove the CTFLM.
• Disconnect (and tag), the wiring harness and utility wires from the Euro block.
• Remove the screws that secure the Euro block in the enclosure, and lift out the Euro block.
• Insert the new Euro block and secure it in the enclosure.
• Reconnect the wiring harness to the Euro block.
• Reinstall the CTFLM.
• Replace/close the enclosure door(s).
• Switch the utility circuit breaker ON.
• Complete Performance Verification. Refer to Initial Startup in the CTFLM/CTSLM User
Manual 990-5501.